Technicolor COM2000 Manuale dell'Operatore Scaricare il pdf (Pagina 20)

Figure 4 - COM46 card

Each COM46 card contains an RF input, 12 indicator lights, a recessed reset button, and

thumbscrews on either end. The cards are hot-swappable, allowing one card to be serviced

independently of the other cards. In order to remove a card, simply loosen the thumbscrews that

secure the card in place and pull it straight out of its slot.

The RF input on a COM46 card feeds a dedicated DIRECTV tuner bank which is capable of

streaming up to eight Pro:Idiom encrypted HD channels simultaneously over the internal

COM360 GbE backplane to an installed QAM6 modulator or one of the two GbE ports on the

COM360 front panel. The COM46 is designed such that each tuner on a card only needs to be

set once. Once configured, the cards should remain locked unless there is a disruption in the

signal due to weather, dish misalignment, or other RF distribution issues. However, the cards

will automatically recover when the disruption to the RF is removed.

The COM46 card only works with DIRECTV input signals in the range of 950 - 2150 MHz as

supplied by a DIRECTV SWiM module. Unlike the legacy COM24 receiver, the COM46 does

not support legacy LNB and multiswitch installations. The RF input system must be built with

SWiM modules.

See Section 8.1 for an explanation of indicator light diagnostic capabilities.

Upper Thumbscrew

Reset Button

Indicator Lights

SWiM Input

Lower Thumbscrew

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 127 128

Nessun commento

Technicolor COM2000 Manuale dell'Operatore Pagina 20